NFPA Tank Placement General Guidelines

The following general guidelines are provided as a starting reference point when building or planning a residential construction or remodel project.  We strongly encourage you to contact Weaver Gas for guidance and safety advice specific to your particular project.

A printable PDF version of these guidelines is available here.
 

Location of DOT Containers

Location of ASME Containers

Notes:

1.  Regardless of its size, any ASME tank filled on-site must be located so that the filling connection and fixed level gauge are at least 10 feet from external sources of ignition (i.e. open flame, window A/C, compressor, etc), intake to direct vented gas appliance or intake to a mechanical ventilation system.

2.  May be reduced to a 10 feet minimum for a single container of 1200 gallons water capacity or less if it is located at least 25 feet from any other LP-Gas container of more than 125 gallons water capacity.

3.  Minimum distances from underground containers shall be measured from the relief valve and filling or level gauge vent connection at the container, except that no part of the underground container shall be less than 10 feet from a building of line of adjoining property which may be built upon.

4.  Where the container may be subject to abrasive action or physical damage due to vehicular traffic or other causes it must be either, (a) placed not less than 2 feet below grade; (b) otherwise protected against such physical damage.
 

All Federal, State and Local ordinances and regulations must be observed at all times.
 

You Can Rely on Weaver Gas Every Step of the Way

Our Weaver energy consultants are experts in their field. For more information about Weaver Gas's Builder and HVAC business programs, contact a Weaver Energy Consultant today.